Question again...

[NJTFAN1235!]

So I was gonna ask you guys, I am gonna modify a activity where the Panbos-Noordvliet section is operated by RSG2. Is there a way I can send the RSG2 to Noordvliet without going on the 3rd rail segment?

[Sjoerd]

The Panbos-Noordvliet section is operated by RSG2 in Rijndam 2006.
The RSG2 cab only be transfered on the 3-rd rail sections of the network (with ATB protection) by another 5200 riding up front, as the RSG2 does not have ATB.

[NJTFAN1235!]

The Panbos-Noordvliet section is operated by RSG2 in Rijndam 2006.
The RSG2 cab only be transfered on the 3-rd rail sections of the network (with ATB protection) by another 5200 riding up front, as the RSG2 does not have ATB.

But isn't a normal one not zub?

[Sgt_DeBones]

For through service, it's impossible for the SG2 and RSG2 to traverse the entire M1 route without doing some switching (shunting). SG2s can't travel on ZUB segments and RSG2s can't travel on ATB segments. Therefore, if you're trying to create an activity using the 5200 class on the full M1 route from end to end, scrap that idea outright and use SG3s instead.