Hello! I was just trying to depart Museumkwartier when this happened...
https://www.youtube.com/watch?v=zOYVOCTCvTI
And I can promise that I wasn't touching the [open doors] button
Door Malfunction
Moderator: senjer
Door Malfunction
Cheers from Finland
Re: Door Malfunction
I tried after that, but it didn't work... still thank you for the potential help
Cheers from Finland
-
- Posts: 149
- Joined: 09 Oct 2015, 18:53
- Location: Amsterdam
- Contact:
Re: Door Malfunction
That means you opened the CVL and I gets all loopy, I had the same thing with throttle.
Just press it again and then close and it will work!
Re: Door Malfunction
When it happens to me, the reason is that the End key stucks. In my keyboard, the End is the same button with the Numpad 1 and I need to toggle the num lock key to use it. If, by mistake, I toggle the num lock button while still pressing the End button it gets stuck and the doors can't close.
You can also try disabling the door protection (Ctrl+Shift+D) for while and then try to close the door, or shut the cab off and then turn it back on.
You can also try disabling the door protection (Ctrl+Shift+D) for while and then try to close the door, or shut the cab off and then turn it back on.
Re: Door Malfunction
Try to enable you doors.
- Attachments
-
- Untitled.jpg (21.34 KiB) Viewed 6353 times
Re: Door Malfunction
Ok, I didn't even notice that the door protection wasn't on... hmmmmm.... still any incidents didn't happen
Cheers from Finland
Re: Door Malfunction
Reminds me of door failures on brand new 81-765 trains when the doors weren't adjusted properly, hit against themselves too hard and triggered safety reopening, it looked exacty like that