Hello everyone again, you know always if I create a train RSG2 in bergpark and want to go to Stadionweg where can I connect to the line correct for this train (RSG2 can only operate on line A between Stadionweg and Springstraat ), I have to go trough a section where is a system ATB and ATB system is not compatible for RSG2 (Only ZUB is compatible for RSG2 ). So if i turn on controls and try to go, the confused ZUB system don't let me go faster then 10 km/h and that's awful. Is there any chance to disable ZUB and go with RSG2 faster?
Brozma
How to disable ZUB in RSG2?
Moderator: senjer
How to disable ZUB in RSG2?
If you want to make a very fast ride, just disable ATB/ZUB, put trottle to 1.00 and enjoy.
In my Avatar is a Logo of a Prague metro.
Sorry for my bad English. I am Czech and i am learning English
In my Avatar is a Logo of a Prague metro.
Sorry for my bad English. I am Czech and i am learning English
Re: How to disable ZUB in RSG2?
You can disable it with Ctrl + Shift + A.
Re: How to disable ZUB in RSG2?
Best way to do so while keeping it realistic (disabling train protection is not allowed unless the line is taken out of service) is to couple a SG2 vehicle in front and drive from that one until the point you can switch, then decouple the vehicle again.
Re: How to disable ZUB in RSG2?
I think this is a difficult way. I think the easier way is disable ZUB and go to the Stadionweg normally.Michiel wrote:Best way to do so while keeping it realistic (disabling train protection is not allowed unless the line is taken out of service) is to couple a SG2 vehicle in front and drive from that one until the point you can switch, then decouple the vehicle again.
If you want to make a very fast ride, just disable ATB/ZUB, put trottle to 1.00 and enjoy.
In my Avatar is a Logo of a Prague metro.
Sorry for my bad English. I am Czech and i am learning English
In my Avatar is a Logo of a Prague metro.
Sorry for my bad English. I am Czech and i am learning English