Screenshots & Videos

[brozma]

Looks good. I already read the page and I wonder, what is meant by that tunnel route mentioned in that page? Is that already present HSL line from Ypenburg to Zeeburg?

[Laurentz von Ungarn]

Yes, there is an HSL-section between Ypenburg and Zeeburg since Rinjdam 1.3. It has ETCS2, so it will can use only with the TRAXX.

[AlistairCowell]

Looks good. I already read the page and I wonder, what is meant by that tunnel route mentioned in that page? Is that already present HSL line from Ypenburg to Zeeburg?

What Sjoerd meant is that a new tunnel has been built between Hondwijk aan Zee and Essim and it is based on the Channel Tunnel that runs from England to France.

[Sjoerd]

Indeed; the tunnel in this video: https://youtu.be/aoU8e3kNfk8

The moment the idea came up to build a Channel Tunnel route, including the terminals at both ends, it was obvious that a shuttletrain would also be required.

BTW It's not really an HSL; the maximum speed in the tunnel is only 160 km/h (also for the HSM if you are using that). But it uses the higer voltage and ETCS, so it does have the look of an HSL.

[A4ex]

Sjoer could you make a video driving the bds ?

[Sjoerd]

https://youtu.be/bDz2ldyh9kM

[Sjoerd]

But can you also do this (third picture)?
https://martijnhaman.nl/typeddar.htm

Perhaps I'll continue on this one some day....



But I don't think I'll be able to make a good "head" for the carriage with driver position.
Perhaps Senjer can.... He did an excelent job on the ICRm BDs carriage

Don't waste your time

@MG2: Please finish your model, it looks very good!
(For those who haven't seen it: http://sim.bemined.nl/forum/viewtopic.p ... 200#p25041)

In the mean time, I think I spend about 16-18 hours on the model since that Sketchup screenshot was made.... Not finished yet, but it will be ready for the RijndamRail update package I plan for the end of the month.
Not the driver cabin carriage, but a middle carriage (so for now; either put an ICRm BDs on the end of your train, or use an NS1700 on both ends).



The upper floor:


Everyone's favorite courner on the top of the stairs

[iamhankhamTS]

Both things looking fab there Sjoerd!

[A4ex]

Sjoerd will you add the ns logo on the Icm ?

[Sjoerd]

Ofcourse, already done